How do i Go about removing the front passenger door pannel on a 1993 Se

I've never done it myself, but I see that no one else has answered yet, so here'* what I know.

There are a few bolts at the bottom front of the door, in the general area of the speaker. The rest of the panel (including the top) is held in position by small metal clips, so you'll just need to pull it carefully at the edges until it pops out.

Good luck,

I wrote up some tech docs a while ago for it. I will see if I can find them again tonight. They were failry specific down to the size of some of the bolt heads.

cool i got the 2 behind the light the 2 by the speaker the one at the top of the handel what else was left
thanks in advance

Which handel? There is one behind the door latch handle (by the lock) and another behind that small strip in the handel you use to pull the door closed, behind the light. That little strip pops out from the front side.

I think that was all of them. You should then be able to pry push clips out and lift the panel off.

the one you use to close the door the other one that you are talking about do i have to remove all of the plastic shroud or what to get to it

The one where there is the light shinning down on the controls pops off and there is a torx (I think it is a torx, maybe a phillips though) behind it. If you carefully pry up the front of it (side closest to the dash) it will just pop out to reveal the screw.

The other one is located behind the door handle that opens the door. This is the handel that is right next to the manual door lock lever. The oval shaped piece behind the handle pops out to reveal the bolt. You might even see a slight slot where you can use a screw driver to pry it out.

Hope this helps.