Gas + Right Turn = Shake
So my car has some shaking when i press the gas around a right turn... it has been going on for a while and since it started i have had
front struts
front tie rods
drivers side lower ball joing
drivers side bearing
four new tires (four wheel alignment)
any ideas?
front struts
front tie rods
drivers side lower ball joing
drivers side bearing
four new tires (four wheel alignment)
any ideas?
Is this a suspension problem or an engine sputtering and gagging problem, if its the later its the famous 92 fuel strainer problem, when coasting or pushing gas around a right corner do you almost run out of gas and have your engine sputter? If so it might be your fuel strainer, me and many others have experienced this problem. If not then i dont know a darn thing about suspension and cant help ya.
Originally Posted by 94bonnyV
anti-sway bar = the bar across the top of the engine compartment?
Originally Posted by Jagman04
Is this a suspension problem or an engine sputtering and gagging problem, if its the later its the famous 92 fuel strainer problem, when coasting or pushing gas around a right corner do you almost run out of gas and have your engine sputter? If so it might be your fuel strainer, me and many others have experienced this problem. If not then i dont know a darn thing about suspension and cant help ya.
it doesnt seem to be engine sputter, more a suspension thing
Does your car have traction control? If so turn off the traction control and see if that makes any difference. Also, do you feel shaking in the steering wheel, the driver'* seat, or both? -Mike
From my limited experience, those symptoms don't sound like a sway bar problem. One of my sway bar endlinks was sheared off and the other one was junk, and the only symptom I had was a clunk when I went over uneven ground or turned a certain way. Plus, if you had all that other steering and suspension work done they probably would have seen a bad endlink while they were under there. I could be wrong, but I doubt it'* the sway bar. Bad news is I don't know enough about it to point you in any other direction! We'll see if a gearhead pops in here.



