1992-1999 Series I L27 (1992-1994 SE,SLE, SSE) & Series II L36 (1995-1999 SE, SSE, SLE) and common problems for the Series I and II L67 (all supercharged models 92-99) Including Olds 88's, Olds LSS's and Buick Lesabres Please use General Chat for non-mechanical issues, and Performance and Brainstorming for improvements.

Fuel Pipe Leaking and Confusion at Dealer

Thread Tools
 
Search this Thread
 
Old Feb 2, 2009 | 05:18 PM
  #1  
jamesvmvmurray's Avatar
Thread Starter
Member
Posts like a V-Tak
 
Joined: Oct 2008
Posts: 63
Likes: 0
jamesvmvmurray is on a distinguished road
Default Fuel Pipe Leaking and Confusion at Dealer

I have a 96SE with a K vin.

There is a leak in the fuel pipe between the fuel filter and the (tank, pump) not sure but the connection is at the top of the tank. The pipe has two connectors on each end.

One dealer says I need the pipe and the connector part # 25613789 #12388064

Another dealer says I just need the pipe which has the connectors #25625186

Is there an after market part, these parts are exp[ensive from GM and I don't have a spare car to allow me to remove the leaking one and take it with me.

Oh by the way they both need to order the part.

Any halp of suggestions would be much appreciated.

Cheers,
James
Reply
Old Feb 2, 2009 | 05:21 PM
  #2  
Danthurs's Avatar
Retired Senior Admin

Expert Gearhead
 
Joined: May 2006
Posts: 29,661
Likes: 43
From: Sheboygan Wisconsin
Danthurs is a name known to allDanthurs is a name known to allDanthurs is a name known to allDanthurs is a name known to allDanthurs is a name known to allDanthurs is a name known to all
Default

Check out Auto Parts Fast at RockAuto I'll go see what I can find.
Reply
Old Feb 2, 2009 | 05:25 PM
  #3  
Danthurs's Avatar
Retired Senior Admin

Expert Gearhead
 
Joined: May 2006
Posts: 29,661
Likes: 43
From: Sheboygan Wisconsin
Danthurs is a name known to allDanthurs is a name known to allDanthurs is a name known to allDanthurs is a name known to allDanthurs is a name known to allDanthurs is a name known to all
Default

This is all I found.
DORMAN Part # 800153 {Original Equipment Solutions}
Includes Seals and Gaskets Needed for Installation; Outlet; Steel Line Gasket - 3/8" x M16-1.50
$7.89$0.00$7.89
DORMAN Part # 800059 {Original Equipment Solutions}
Includes Seals and Gaskets Needed for Installation; Inlet; Nylon Elbow - 3/8" x 3/8"
$12.16$0.00$12.16
DORMAN Part # 800058 {Original Equipment Solutions}
Includes Seals and Gaskets Needed for Installation; Inlet; Nylon Straight - 3/8" x 3/8"
$12.16$0.00$12.16
DORMAN Part # 55180 {Steel Fuel Line Repair 3/8" tube x 18" Length w/compression fitting}
Includes Seals and Gaskets Needed for Installation; Outlet; Steel Line Gasket - 3/8" x M16-1.50
$13.94$0.00$13.94
Reply
Old Feb 2, 2009 | 05:57 PM
  #4  
jamesvmvmurray's Avatar
Thread Starter
Member
Posts like a V-Tak
 
Joined: Oct 2008
Posts: 63
Likes: 0
jamesvmvmurray is on a distinguished road
Default

Thnks for the info, I guess I am going to need to take it off first, from what I see there are no metal tubing parts, the connectors look about right though, at least on the fuel filter.
Reply
Old Feb 3, 2009 | 12:34 AM
  #5  
jamesvmvmurray's Avatar
Thread Starter
Member
Posts like a V-Tak
 
Joined: Oct 2008
Posts: 63
Likes: 0
jamesvmvmurray is on a distinguished road
Default

I was able to find the part,

I am wondering if I need to drop the tank to do this replacement, the fuel pipe has quick connectors on each end. When I saw my car up on the hoist I could see both ends but was not sure I could get to the one above that tank to remove or replace it.

Anyone done this???

Cheers,
James
p.*. the dealer told me $200 labor for the job.
Reply
Old Feb 3, 2009 | 01:25 AM
  #6  
buckykattnj's Avatar
Senior Member
Posts like a 4 Banger
 
Joined: Aug 2007
Posts: 126
Likes: 3
From: South Jersey/NYC
buckykattnj is on a distinguished road
Default

When I replaced my fuel sender, one of the hoses didn't seal right. Of course, I didn't discover this until everyhting was buttoned up.

I have large hands, but I was able to let the fuel tank down a bit, without completely removing the strap, giving my just enough room to remove the clip and pull the hose off and replace it.

There had been some disagreement on if it can be done without dropping the tank, so it may vary per car. In my case, it could.

Are you certain the fitting is leaking? In my case, I thought it was the fitting, and it turned out my sending unit was full of pin holes... and needed replacement. Unfortunately, THAT requires the tank to be dropped... a major PITA.

BKNJ
Reply
Old Feb 3, 2009 | 06:01 PM
  #7  
jamesvmvmurray's Avatar
Thread Starter
Member
Posts like a V-Tak
 
Joined: Oct 2008
Posts: 63
Likes: 0
jamesvmvmurray is on a distinguished road
Default

Well, So far so good. The new fuel pipe seems to have stopped the leak.

Info

Dealer wanted to charge me $200 plus parts, said he needed to drop tank.

Local repair shop did it in 15 minutes, didn't drop the tank and replaced a burnt license plate bulb $25

Jeez, i guess GM was trying to get more bailout funds.
Reply
Old Feb 3, 2009 | 06:46 PM
  #8  
Danthurs's Avatar
Retired Senior Admin

Expert Gearhead
 
Joined: May 2006
Posts: 29,661
Likes: 43
From: Sheboygan Wisconsin
Danthurs is a name known to allDanthurs is a name known to allDanthurs is a name known to allDanthurs is a name known to allDanthurs is a name known to allDanthurs is a name known to all
Default

2000+ have a access door to the fuel pump. The older ones you can just undo teh straps and lean the tank. Tight fit but no need to drop it all the way.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
chevelle_6969
1992-1999
9
Mar 21, 2011 10:35 AM
XEN
2000-2005
13
May 1, 2009 09:01 PM
dougd7
General GM Chat
2
Oct 19, 2008 05:45 PM
PaulDFixr
1992-1999
9
Apr 18, 2006 09:15 AM




All times are GMT -4. The time now is 09:42 PM.