1995 ac problem
#1
Member
Posts like a V-Tak
Thread Starter
Join Date: Sep 2004
Posts: 37
Likes: 0
Received 0 Likes
on
0 Posts
1995 ac problem
My 1995 ac temp display is blinking and no cold air is blowing. I tried to do the test that'* on the techinfo but it doesnt work. Since this is a 95, is there another way to check the electronic climate? Thanks
#2
Senior Member
True Car Nut
Join Date: Sep 2004
Location: Farmington, Minnesota =MWBF '05 SURVIVOR= =CEBF '06 SURVIVOR= =August '06 COTM=
Posts: 9,130
Likes: 0
Received 0 Likes
on
0 Posts
When the display is blinking it means that there'* a fault code in the HVAC system and can only be pulled by the dealer. Since it isn't blowing cold air and it'* blinking, I'm willing to bet that you're running low on refrigerant. When was the last time you had it recharged? Best way to tell if your car is low on refrigerant, start the car and crank the A/C and get out of the car and check and see if the compressor clutch engages at all, if it doesn't engage then the compressor could be bad or the system is low. More than likely the system is just low. I hope this helps.
Nate
Nate
#3
Senior Member
True Car Nut
If could also be the air mix door motor. This opens or closes according to the set temp. All the way open for full hot and all the way closed for full cold.
#4
Junior Member
Posts like a Ricer Type-R
The refrigerant may have nothing to do with it. The ECC unit will prevent the compressor clutch from engaging in a fault status. ANY fault status.
Dealer needs to pull the codes or clear/reset it. Some codes are minor. Cross your fingers.
Dealer needs to pull the codes or clear/reset it. Some codes are minor. Cross your fingers.
#5
Senior Member
True Car Nut
Join Date: Sep 2004
Location: Farmington, Minnesota =MWBF '05 SURVIVOR= =CEBF '06 SURVIVOR= =August '06 COTM=
Posts: 9,130
Likes: 0
Received 0 Likes
on
0 Posts
Once again I have been out done...hahaha....Well I tried.....May have been on the right track. Oh well. Personal exp. I recharged mine and everything started workin again. FWIW.
Nate
Nate
#6
Member
Posts like a V-Tak
Thread Starter
Join Date: Sep 2004
Posts: 37
Likes: 0
Received 0 Likes
on
0 Posts
1995 ac problem
freon level is good. still have the blinking numbers.
compressor kicks on sometimes. is there anyway i can pulled the codes without going to the dealer? HELP
compressor kicks on sometimes. is there anyway i can pulled the codes without going to the dealer? HELP
#9
Senior Member
True Car Nut
Join Date: Sep 2004
Location: Farmington, Minnesota =MWBF '05 SURVIVOR= =CEBF '06 SURVIVOR= =August '06 COTM=
Posts: 9,130
Likes: 0
Received 0 Likes
on
0 Posts
No, that has absoulutley nothing to do with the HVAC system. A parts store or standard scan tool can't scan the HVAC systems. Only the dealer. The QDM 1 failure you're getting is the samething I'm getting which means something like low speed fan error or something.....Do a search on QDM 1 and it'll pop up here on the site....Because I've got the same error along with a few other people that have posted it here on the site.
Thread
Thread Starter
Forum
Replies
Last Post
killer_cr80r
General GM Chat
27
10-26-2019 07:21 AM