1992-1999 Series I L27 (1992-1994 SE,SLE, SSE) & Series II L36 (1995-1999 SE, SSE, SLE) and common problems for the Series I and II L67 (all supercharged models 92-99) Including Olds 88's, Olds LSS's and Buick Lesabres Please use General Chat for non-mechanical issues, and Performance and Brainstorming for improvements.

ABS (errrr!!!)

Thread Tools
 
Search this Thread
 
Old Apr 1, 2004 | 03:56 PM
  #1  
al's Avatar
al
Thread Starter
Member
Posts like a V-Tak
 
Joined: May 2003
Posts: 77
Likes: 0
From: Toronto
al is on a distinguished road
Default ABS (errrr!!!)

So here'* the situation. I stopped to get gas, fill up, turn the car back on and there was a vibrating noise coming out from the front wheels, then the ABS/TC lights came on. the lights then came on and off as i was driving today. Loose wires? Safe to drive? Any opinions would be great. Thanks.
Reply
Old Apr 1, 2004 | 04:59 PM
  #2  
Drifter420's Avatar
Senior Member
True Car Nut
 
Joined: Jun 2002
Posts: 3,266
Likes: 1
From: Bedroom, Ontario
Drifter420 is on a distinguished road
Default

sounds like a speed sensor.. you're going to have to pull your wheel off each wheel or have it up on ramps to see if the connector is right or not.. get 2 paper clip.. bend them up.. and read the ohms reading on each sensor in the hub bearings to see if one of them is way off
Reply
Old Apr 20, 2004 | 03:32 PM
  #3  
mark2112's Avatar
Junior Member
Posts like a Ricer Type-R
 
Joined: Apr 2004
Posts: 20
Likes: 0
From: Bellbrook, OH
mark2112 is on a distinguished road
Default ABS Wheel Sensors

[quote]Posted: Thu Apr 01, 2004 4:59 pm
--------------------------------------------------------------------------------

sounds like a speed sensor.. you're going to have to pull your wheel off each wheel or have it up on ramps to see if the connector is right or not.. get 2 paper clip.. bend them up.. and read the ohms reading on each sensor in the hub bearings to see if one of them is way off


I measured both sides, readings are 100 ohms and 500 ohms........which one is bad?
I would assume that the 100 ohms sensor is....anyone know what it should read?


Thanks, again
MarkH
Reply
Old Apr 20, 2004 | 09:08 PM
  #4  
A Bonnie Canuck's Avatar
Senior Member
Posts like a Turbo
 
Joined: Sep 2003
Posts: 376
Likes: 0
From: Halifax Nova Scotia ASE Master Service Tech
A Bonnie Canuck is on a distinguished road
Default

measure one of the rear ones...2 out of 3 ain't bad (hope that isn't lost on everyone )
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
B4CTROOPER
2000-2005
1
Jan 4, 2010 05:53 PM
ptrfair
2000-2005
0
Dec 11, 2007 07:33 PM
jessie_harbin
1992-1999
23
Dec 17, 2005 06:30 PM
willwren
1992-1999
12
Sep 24, 2002 12:02 PM




All times are GMT -4. The time now is 10:34 AM.