2 codes after TPS mod
#1
Senior Member
True Car Nut
Thread Starter
Join Date: Feb 2003
Posts: 3,684
Likes: 0
Received 0 Likes
on
0 Posts
2 codes after TPS mod
Sat. night I attempted the TPS optimization, didnt get it to where I wanted because I lost the torx driver and couldnt get the sensor to twist enough. Anyway on the way to work this morning I noticed the CEL light come on, so after work I went to Autozone to have them pulled. Heres what they found: P0113 IAT circuit high input. And,
P0122 TPS circuit low input.
I dont understand why either one went off. I did mangage to get the TPS from 3.9X to 4.06. Any ideas?
P0122 TPS circuit low input.
I dont understand why either one went off. I did mangage to get the TPS from 3.9X to 4.06. Any ideas?
#3
Senior Member
True Car Nut
Join Date: Sep 2002
Location: Genoa, Illinois
Posts: 4,013
Likes: 0
Received 0 Likes
on
0 Posts
CEL came on when I did it, but it went off after a few start ups...probably learning new voltage numbers was my problem. You want idle between .70 - .71 and WOT between 4.30 - 4.35. Make sure idle isn't over .75 or the TB plate will be open too much.
#5
Senior Member
True Car Nut
Thread Starter
Join Date: Feb 2003
Posts: 3,684
Likes: 0
Received 0 Likes
on
0 Posts
Ok, maybe it was just relearning. I'll wait and see if they come back on. The guy that pulled the codes at Autozone thought my car was nice. He was a bit suprised that the interior was plan Jane.
#7
Senior Member
True Car Nut
Join Date: Jan 2003
Location: Bloomington-Normal, IL 1997 SE
Posts: 3,734
Likes: 0
Received 0 Likes
on
0 Posts
Mine set off the CEL, dont worry about it, the code goes away after a day or two. Check to make sure you dont have an IAT short.
Thread
Thread Starter
Forum
Replies
Last Post
Boreas
Performance, Brainstorming & Tuning
8
02-08-2006 06:29 PM
big_news_1
Performance, Brainstorming & Tuning
26
01-27-2006 01:56 PM