CASE Learn Question
#1
Member
Posts like a V-Tak
Thread Starter
Join Date: Jul 2008
Location: Burnsville Minnesota
Posts: 33
Likes: 0
Received 0 Likes
on
0 Posts
CASE Learn Question
Anybody know if you can do a CASE learn procedure with an AutoTAP scan tool and laptop? I know that it is probably not possible with the AutoTAP software itself but maybe there is some other software out there that can do it??????
#2
Retired Senior Admin
Expert Gearhead
Join Date: May 2006
Location: Sheboygan Wisconsin
Posts: 29,661
Likes: 0
Received 28 Likes
on
24 Posts
AutoEnginuity is one that does it. you need to start the procedure and then floor it so it goes to the rev limiter. That'* it. You may have to do it more then once. The software will let you know.
#4
Member
Posts like a V-Tak
Thread Starter
Join Date: Jul 2008
Location: Burnsville Minnesota
Posts: 33
Likes: 0
Received 0 Likes
on
0 Posts
Well i tried AutoEnginuity and it will not work with my autotap scan tool. It will recognize it as "Hardware" but it can not communicate through it. Do you know of any other program that will do this?
Thread
Thread Starter
Forum
Replies
Last Post
GTPboy
Performance, Brainstorming & Tuning
11
04-20-2006 03:07 PM