Belt size after pulley upgrade?
#1
Member
Posts like a V-Tak
Thread Starter
Join Date: Feb 2006
Location: West Michigan
Posts: 80
Likes: 0
Received 0 Likes
on
0 Posts
Belt size after pulley upgrade?
Iv'e looked around the forums and couldn't come up with any information on what size belt is reccomended after a 2.3" */c pulley was added. So I'm just wondering what size belt should I look for. Ever since the new pulley was added Iv'e witnessed a loud squek.... please help me determine the correct size of the new belt i need.
#2
Senior Member
Certified GM nut
Join Date: May 2005
Location: Wickliffe, Ohio
Posts: 2,155
Likes: 0
Received 0 Likes
on
0 Posts
If I'm correct the stock size pulley for your car is 2.55" and you have a 2.3". I would think you should be able to use a stock size belt but should probably use a oversized tensior pulley to pick up the slack and give you more belt wrap on the SC pulley & there for elimating or reducing that squeak (belt slippage) you hear.
Ed
Ed
#4
Senior Member
Certified GM nut
Join Date: May 2005
Location: Wickliffe, Ohio
Posts: 2,155
Likes: 0
Received 0 Likes
on
0 Posts
You can buy one at your local NAPA or Autozone; I won't be much help with part numbers though. Or you could get one off of Intense'* site
Ed
Ed
#5
Junior Member
Posts like a Ricer Type-R
Beckster, did you know about Techinfo?
http://www.bonnevilleclub.com/forum/...e=article&k=46
Moving to Forced Induction.
http://www.bonnevilleclub.com/forum/...e=article&k=46
Moving to Forced Induction.
Thread
Thread Starter
Forum
Replies
Last Post
Mark Peters
Performance, Brainstorming & Tuning
10
03-21-2003 08:42 PM