keyless remote

Reply Subscribe

Thread Tools

Search this Thread

05-18-2013, 02:46 PM

farmall

Junior Member

Posts like a Ricer Type-R

Thread Starter

Join Date: Oct 2008

Posts: 12

Likes: 0

Received 0 Likes on 0 Posts

keyless remote

got a keyless remote transmitter at junk yard. can I program it my self or must I take it to a dealer ?

Reply Like

05-18-2013, 08:48 PM

Mike

Retired

Certified Car Nut

Join Date: Jul 2003

Location: Dark Side, AZ

Posts: 17,920

Likes: 498

Received 1,780 Likes on 1,304 Posts

I wasn't sure if the procedure was the same as the trucks. Apparently it is.

This should work for you....

1. Remove the key from the ignition.
2. Close all doors.
3. Remove the "MALL PGM" fuse from the fuse panel. Use the legend on the fuse panel or
owner'* manual to properly locate the "MALL PGM" fuse.
4. Insert the key into the ignition, and turn to the ACC position.
5. Turn the key to OFF and then back to ACC within 1 second.
6. Open and close any vehicle door. A chime will be heard when the system enters into
programming mode.
7. Press and hold the remote LOCK and UNLOCK buttons simultaneously for 14 seconds.
IMPORTANT: After 7 seconds, a chime may be heard confirming successful
synchronization. It is necessary to wait approximately 14 seconds for a second chime
that will confirm successful programming.
8. Repeat step 7 now for each additional remotes to be programmed including any existing
remotes.
9. Remove key from ignition.
10. Install the "MALL PGM" fuse back into the fuse panel and test remote(*).

__________________
Retired Administrator
2002 *-10 5.7 V8
2023 Jeep Rubicon Diesel