Need some quick help - Crank Sensor
#1
Junior Member
Posts like a Ricer Type-R
Thread Starter
Join Date: Feb 2003
Location: Missouri
Posts: 21
Likes: 0
Received 0 Likes
on
0 Posts
Need some quick help - Crank Sensor
Can someone please verify for me that on the 1990 Bonneville on the ICM connector at pins G (18x signal) and H (Sync signal). That the values are supposed to be 5v for G and 9v for H. I could have swore that I read that the voltages were supposed to mV values. I installed a new crank sensor after installing some jumper leads on the harness and was not getting any voltage from the crank sensor. Now that I have replaced the sensor and the engine is running (not quite a smooth as I think it should be) I am getting voltages that I think are high.
#3
Senior Member
True Car Nut
Join Date: Nov 2002
Location: Texarkana, Texas
Posts: 6,042
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by BillBoost37
Nothing that I remember is mV, should be V only IIRC
Unless you've got an o-scope and you're watching the waves... you're going to see V.
Thread
Thread Starter
Forum
Replies
Last Post
PStan
Chevrolet
7
03-17-2019 02:26 PM