2004 Envoy need help please
#1
Junior Member
Posts like a V-Tak
Thread Starter
2004 Envoy need help please
Hello All
The **** on the dual temp. control slide bar came off on the wife the other day and I cannot seem to get it back on. It is in the hot position (all the way up) I can slide it to the cold position with a pocket screwdriver but cannot get the **** back on. What is the trick here. I have never had this problem on any vehicle in my life. Looks like it should just push back on, but I can't seem to get it to go on.
Any help would be appreciated.
Thanks Mike
The **** on the dual temp. control slide bar came off on the wife the other day and I cannot seem to get it back on. It is in the hot position (all the way up) I can slide it to the cold position with a pocket screwdriver but cannot get the **** back on. What is the trick here. I have never had this problem on any vehicle in my life. Looks like it should just push back on, but I can't seem to get it to go on.
Any help would be appreciated.
Thanks Mike
The following users liked this post:
CathedralCub (04-02-2023)
#2
Senior Member
If you can;t tell by looking I do not know what you think we can do. If I could see it then maybe.
The following users liked this post:
CathedralCub (04-02-2023)
The following users liked this post:
CathedralCub (04-02-2023)
The following users liked this post:
CathedralCub (04-02-2023)
#5
Senior Member
They both look to be on to me. I was thinking of the **** not the panel.
The following users liked this post:
CathedralCub (04-02-2023)
#6
Junior Member
Posts like a V-Tak
Thread Starter
That is an old pic. from when i was showing a friend something else. Right now the pass. side is off and I can not get it to push back on, womdering if it is held on with a clip or something that might have fallen off.I tried goggling it with no luck.
Thanks Mike
Thanks Mike
The following users liked this post:
CathedralCub (04-02-2023)
#7
Senior Member
True Car Nut
Can you get us a picture of the piece that came out and a view into the slot?
#8
Senior Member
It'* likely cracked and won't grab.
The following users liked this post:
CathedralCub (04-02-2023)
The following users liked this post:
CathedralCub (04-02-2023)
#10
Senior Member
You need to pull the bezel.
The following users liked this post:
CathedralCub (04-02-2023)