GM Forum - Buick, Cadillac, Olds, GMC & Pontiac chat - Search Results

 
Search: Posts Made By: CathedralCub
Showing results 1 to 25 of 375
Search took 0.02 seconds.
Forum: Pontiac
06-20-2019, 11:05 AM
Replies: 3
Views: 224
Posted By rjolly87

As mentioned, the market for the series 1 was...

As mentioned, the market for the series 1 was pretty limited. Willwren from days of old had about the most extensively modified 92-95 in the history of the forum that I am aware of, but he is since...
Forum: Oldsmobile
06-19-2019, 09:59 PM
Replies: 4
Views: 482
Posted By Canuckmeister

Final tip

the balance the balance shaft bearing which is press-fit into the rear block bore much the same as a camshaft bearing is difficult to locate when to stop moving it in. Don't try to reinstall one of...
Forum: Cadillac
06-19-2019, 08:15 PM
Replies: 10
Views: 623
Posted By dpieroni3

Vehicle Inquiry System. Has info on warranty,...

Vehicle Inquiry System. Has info on warranty, warranty repairs, vehicle build, applicable recall info.
Forum: Cadillac
06-19-2019, 10:47 AM
Replies: 10
Views: 623
Posted By Soft Ride

depeironi3- What is a VIS or did you mean VIN...

depeironi3- What is a VIS or did you mean VIN number for remaining warranty check in post #5 ?


This is where some local calls should be made. In the USA what normally are the rules regarding...
Forum: Cadillac
06-18-2019, 07:09 PM
Replies: 10
Views: 623
Posted By dpieroni3

Today I spoke with our warranty clerk and was...

Today I spoke with our warranty clerk and was told that as long as the repair needed fall under the vehicles warranty it should be covered as long as the warranty has not expired by time or mileage....
Forum: 2000-2005
06-03-2019, 08:53 PM
Replies: 3
Views: 770
Posted By Soft Ride

One idea you could try, remove battery terminals,...

One idea you could try, remove battery terminals, and spray down the entire switch assembly with electrical contact cleaner.
Then use compressed air and repeat a few times, that may get things...
Forum: Cadillac
06-03-2019, 06:17 AM
Replies: 9
Views: 813
Posted By losagin

TechII...You hit it. The relay was in the door...

TechII...You hit it. The relay was in the door sill.Had a heck of a time finding it, but now I've got everything working again. Many Thanks
Forum: Buick
05-30-2019, 01:06 AM
Replies: 15
Views: 1,708
Posted By pjmia96

I never figured out the misfire on the car but a...

I never figured out the misfire on the car but a brand new "Delco" ignition control module got this car back on its feet again for the next two years! The standard motor products "Magnavox ICM's are...
Forum: Oldsmobile
05-30-2019, 12:37 AM
Replies: 9
Views: 1,759
Posted By pjmia96

It started out as just code 26 and after a long...

It started out as just code 26 and after a long time code 63 popped up as well. Code 63 indicates a problem in circuit number 697 which is the blue wire on the EGR valve. I traced that wire back to...
Forum: Oldsmobile
05-28-2019, 08:42 PM
Replies: 9
Views: 1,759
Posted By pjmia96

I'm a little late, but I should share that a...

I'm a little late, but I should share that a replacement EGR Valve fixed this problem. Hopefully that information will help someone else out there.

Matt
Forum: Buick
05-09-2019, 08:46 PM
Replies: 8
Views: 354
Posted By BossHog39

https://cimg0.ibsrv.net/gimg/www.gmforum.com-vbull...

https://cimg0.ibsrv.net/gimg/www.gmforum.com-vbulletin/595x375/20190505_102517_cfdf618a66e30aaf91505048b784a006a678a450_16d39c394d85218b0b7b8e98fdf1503551f11097.jpg
You Can See In the Pic that the...
Forum: Lounge
05-07-2019, 08:11 AM
Replies: 9
Views: 249
Posted By Mike

Hola!!

Hello from Cozumel Mexico!!
https://cimg2.ibsrv.net/gimg/www.gmforum.com-vbulletin/2000x1504/img_20190507_080735_5dc9d415d7c6e7941a39f5c7258f860f5ffdef5e.jpg
Forum: Lounge
05-07-2019, 08:09 AM
Replies: 20
Views: 607
Posted By GunsOfNavarone

Mike, are you now in AZ? If so you may have a...

Mike, are you now in AZ? If so you may have a visitor. I am in Salt Lake City. Going to St George today or tomorrow to look at a 2002 F350 with 7.3l diesel. My 2007 F350 with 5.4 gas had another plug...
Forum: Buick
03-29-2019, 01:05 PM
Replies: 6
Views: 238
Posted By hittleconstruc

Thanks for the info. I will not have time this...

Thanks for the info. I will not have time this weekend work on it but as soon as i do I will post pics and progress. Thanks again
Forum: Buick
03-28-2019, 09:07 PM
Replies: 6
Views: 238
Posted By Tech II

1. rotate seat down 2. remove the left and rear...

1. rotate seat down
2. remove the left and rear upper quarter panels.....
3. remove the 3 front pins
4. Lift up rear panel assembly, slide seat belts out of panel, and disconnect electrical...
Forum: Chevrolet
03-14-2019, 10:17 PM
Replies: 6
Views: 275
Posted By Tech II

O2 sensor 1 is reading the oxygen in the...

O2 sensor 1 is reading the oxygen in the exhaust....this sensor data is used to control fuel air mixture.....the rapid changing is a normal waveform because the PCM is trying to maintain a 14.7/1...
Forum: Buick
03-11-2019, 05:26 PM
Replies: 48
Views: 1,191
Posted By carfixer007

I'm pretty sure the actuators for the air flow...

I'm pretty sure the actuators for the air flow are vacuum operated but I'm not sure the blend door is.
Can you tell if the actuator for the blend door is electrical. If so, the system may benefit...
03-11-2019, 09:07 AM
Replies: 1
Views: 327
Posted By Mike

Yes, the VIN will need to be programmed in. If...

Yes, the VIN will need to be programmed in. If you swap it now before leaving, you may not be able to start your car.
Forum: Buick
03-06-2019, 05:44 PM
Replies: 50
Views: 1,309
Posted By carfixer007

Here's a wiring diagram. The full diagrams for...

Here's a wiring diagram. The full diagrams for the PCM. I have the factory info for your vehicle.
You are in limp mode. I wouldn't drive it like that or you'll lose the transaxle.
Do you have a...
Forum: Saturn
03-03-2019, 03:00 PM
Replies: 13
Views: 506
Posted By Tech II

FOUND THIS: See the first important...

FOUND THIS:

See the first important remark....may be able to program via the DIC.....
...
Forum: Saturn
03-03-2019, 02:55 PM
Replies: 13
Views: 506
Posted By Tech II

Apparently, AP3 means it already comes with those...

Apparently, AP3 means it already comes with those remotes......AP8 is apparently remote start ready, just need the remotes.....

The only caveat is, a dealership is going to have to program those...
Forum: Saturn
03-01-2019, 10:07 PM
Replies: 13
Views: 506
Posted By Tech II

From what I read, the words "if equipped" keep...

From what I read, the words "if equipped" keep popping up.......

There are some vehicles that can have the options programmed "on".....I don't think this is one of them....

The basic parts are...
Forum: Chevrolet
02-25-2019, 12:15 PM
Replies: 7
Views: 394
Posted By Drm3105

Well it has been a busy couple of weeks! I've...

Well it has been a busy couple of weeks! I've been slowly getting work done on the car and as of last Friday, it was running again. I replaced the upper intake manifold, grabbed a used fuel rail and...
Forum: Pontiac
02-23-2019, 09:37 PM
Replies: 50
Views: 1,404
Posted By Tech II

Here is an old trick: Disconnect the single...

Here is an old trick:

Disconnect the single wire O2 sensor.......turn key to on, don't start.....observe O2 voltage....should be around 0.455 volts in data.... now take a wire and attach it the...
Forum: Buick
02-18-2019, 12:48 AM
Replies: 31
Views: 928
Posted By carfixer007

Here's the flow chart and vacuum and wiring...

Here's the flow chart and vacuum and wiring diagrams. You should be good to go with these....
Showing results 1 to 25 of 375
 


 

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.