what have i done?!?!?
#1
Member
Posts like a V-Tak
Thread Starter
what have i done?!?!?
changing struts on my 2006 Montana.thought I would remove under hood fuse and breaker panel to get a better look. pulled it out of it'* connectors. put it back in but van wont start. every thing comes on radio dash lights ect.what has happened? is it a security feature?
#2
Senior Member
True Car Nut
sounds like a fuse blew, they have open connections on the back that can cause a short. have to find the feed fuse, sometimes its on the same panel sometimes its on a different one.
#4
Senior Member
True Car Nut
i think the breakers are thermal resetting and if it was that it would reset when it cooled. normally they put those on motor circuits like fans. if i had to guess it would be one of the bigger ones, "maxi" fuses if your vehicle had those
#5
Member
Posts like a V-Tak
Thread Starter
crisis averted!! as I stared into the fuse and breaker box I noticed that one of the middle connector box was lower than the two on the ends. it had slipped past it'* tabs that hold it up. I reset it up in position and it connected. very thing works fine. in my haste and panic to plug it back in the first time I must have pushed too hard. feel stupid! lesson learned. till next time. thanks Justin!
The following users liked this post:
WilliamE (07-28-2014)
Thread
Thread Starter
Forum
Replies
Last Post
Stinger357
2000-2005
11
02-02-2010 09:58 AM
turtle_time85
General GM Chat
1
04-21-2007 01:51 AM
ComfyCar
General GM Chat
21
05-08-2005 08:26 PM