No drive in drive
#1
Senior Member
Certified GM nut
Thread Starter
No drive in drive
Talk about bad timing. After a day of driving all over, I shifted into drive, tapped the gas, and the engine revved and it would not move at all. I put it into first or second (can't remember which), the transmission started shaking, but then it began limping enough to be drivable.
Fluid seems full (can't tell the color in the dark). No codes, it seems. Is this just a common solenoid failure, or is it really cooked? Original transmission, 186,000 miles.
Fluid seems full (can't tell the color in the dark). No codes, it seems. Is this just a common solenoid failure, or is it really cooked? Original transmission, 186,000 miles.
#2
Retired
Did you check for codes, or are you going by the CEL? Many transmission codes will not set off the CEL.
__________________
Retired Administrator
2002 *-10 5.7 V8
2023 Jeep Rubicon Diesel
Retired Administrator
2002 *-10 5.7 V8
2023 Jeep Rubicon Diesel
#3
Senior Member
Certified GM nut
Thread Starter
Nope, my scanner reported no codes at all. When you put it into drive, the RPM'* take about 3-5 seconds to change, but the car will still not move in D; only in 1, 2, and a little bit in 3.
The fluid smells okay, but it turned brown very quickly. There'* also a constant whining while it'* driven.
The fluid smells okay, but it turned brown very quickly. There'* also a constant whining while it'* driven.
#4
Retired
Brown means the fluid is burnt and from the sound of it, its metal-metal clutch packs. Sorry to say, its time for a rebuild.
__________________
Retired Administrator
2002 *-10 5.7 V8
2023 Jeep Rubicon Diesel
Retired Administrator
2002 *-10 5.7 V8
2023 Jeep Rubicon Diesel
#5
Senior Member
If you pull the pan and there isn't any glitter you might just have a bad pressure control solenoid. Too bad to replace the solenoid you darn near need to remove the transmission to get the side cover off to service the electronics. I would check the line pressure and go from there.
#6
Senior Member
Most home scanners wont read body codes or transmission.
I am not sure Colin what scanner u have but u may have to take it to someone that has a pro or shop scanner that can do a complete read of pending or stored codes.
I am not sure Colin what scanner u have but u may have to take it to someone that has a pro or shop scanner that can do a complete read of pending or stored codes.
__________________
1997 Buick Pk Ave (Soft Ride) Suspension!
1997 Buick Pk Ave (Soft Ride) Suspension!
Thread
Thread Starter
Forum
Replies
Last Post