Thoughts about engine heat
#1
Senior Member
True Car Nut
Thread Starter
Join Date: Feb 2004
Location: Pennsylvania
Posts: 5,177
Likes: 0
Received 0 Likes
on
0 Posts
Thoughts about engine heat
Two questions I was thinking about
1. Has anyone here tried to wire up a small 4 or 6 inch 'sucking' fan that is placed on the underside of the hood, and is directly underneath a hood scoop so the hot air may be allowed to flow out of the engine bay? Theoritically could that work?
2. Thinking about CAI, and what is the best way to make a shield. I know this helps out, but is it critical that a shield is made? Fiberglass ok or is plastic stong enough not to melt? Where should the cone be covered at. Top, bottom, etc...
1. Has anyone here tried to wire up a small 4 or 6 inch 'sucking' fan that is placed on the underside of the hood, and is directly underneath a hood scoop so the hot air may be allowed to flow out of the engine bay? Theoritically could that work?
2. Thinking about CAI, and what is the best way to make a shield. I know this helps out, but is it critical that a shield is made? Fiberglass ok or is plastic stong enough not to melt? Where should the cone be covered at. Top, bottom, etc...
Thread
Thread Starter
Forum
Replies
Last Post