Doing plugs and wires?
#1
Senior Member
Posts like a Northstar
Thread Starter
Join Date: Aug 2003
Location: Buffalo Grove, IL
Posts: 666
Likes: 0
Received 0 Likes
on
0 Posts
Doing plugs and wires?
Should I go to a colder set of plugs right away? I am planning on doing a 3.4" pulley swap very soon. Can i run a colder set of plugs on a stock engine without much problem?
#5
Senior Member
Posts like a Turbo
Join Date: Sep 2004
Location: Canton, Ga
Posts: 253
Likes: 0
Received 0 Likes
on
0 Posts
I use Autolite 104'* so far. I only have about 100 miles on them though.
I drove about 50 miles with a stock engine, Did my mods and have driven about 50 since.
They looked fine at last check. Several members here mentioned the 104'* were too cold however.
The article Will mentions 104'* and 605'* I think.
JLathem
I drove about 50 miles with a stock engine, Did my mods and have driven about 50 since.
They looked fine at last check. Several members here mentioned the 104'* were too cold however.
The article Will mentions 104'* and 605'* I think.
JLathem
#6
Senior Member
Posts like a Northstar
Thread Starter
Join Date: Aug 2003
Location: Buffalo Grove, IL
Posts: 666
Likes: 0
Received 0 Likes
on
0 Posts
605'* are 1 heat range colder than stock
104'* are 2 heat ranges colder
103'* are 3 heat ranges colder
Those are all autolite numbers. Not sure about any colder, as you would have a crazy car, and should know by then
104'* are 2 heat ranges colder
103'* are 3 heat ranges colder
Those are all autolite numbers. Not sure about any colder, as you would have a crazy car, and should know by then
Thread
Thread Starter
Forum
Replies
Last Post
zzzzzeke
Performance, Brainstorming & Tuning
3
03-17-2003 08:24 AM
buickpower3800sc
Performance, Brainstorming & Tuning
4
03-15-2003 04:27 PM