Is this Normal?
#1
Senior Member
Posts like a Turbo
Thread Starter
Join Date: Jan 2005
Location: Pawtucket, RI
Posts: 333
Likes: 0
Received 0 Likes
on
0 Posts
Is this Normal?
Watch this video and tell me if that fluttering whine noise is a normal thing. I get ti mostly at low psi like 1-7 as you can see any advice is appreciated.
Note* Never had flutter noise before pulley and belt exchange
http://media.putfile.com/DSCF0377
Note* Never had flutter noise before pulley and belt exchange
http://media.putfile.com/DSCF0377
#3
Senior Member
True Car Nut
Join Date: May 2003
Location: Lethbridge, Alberta, _______Canada._______ West Coast Bonneville Fest ___05,06,07 Survivor___
Posts: 8,135
Likes: 0
Received 0 Likes
on
0 Posts
first things first to correctly diagnose a slipping belt... buy some belt dressing, spay it on the side of the belt that rides on the SC pulley..then take it out for another drive..if its still there...maybe look elsewere...also check for micro black belt shavings under the SC...this would also be another symptom of a slipping belt.
#4
Senior Member
Certified GM nut
Join Date: May 2005
Location: Wickliffe, Ohio
Posts: 2,155
Likes: 0
Received 0 Likes
on
0 Posts
Did you happen to change plugs when you did the pulley swap? I know after I did mine I had 1 range to cold and my car didn't like them so it would make that noise whenever the motor made boost. Plus you could feel it missfire, it ran amazing as long as there was no boost. I'm going to try and see if I can find a video that I took of mine when it was doing it........
Here is the link http://media.putfile.com/MVI_153468 I'm sorry it is so hard to hear but I was going like 70mph at the time.
Here is the link http://media.putfile.com/MVI_153468 I'm sorry it is so hard to hear but I was going like 70mph at the time.
#6
Senior Member
Posts like a Turbo
Thread Starter
Join Date: Jan 2005
Location: Pawtucket, RI
Posts: 333
Likes: 0
Received 0 Likes
on
0 Posts
Does the local advanced have belt dressing? I also changed the oil fule filter oil filter pcv valve 02 sensor plugs wires new air filter. I also checked the compression of all the cylinders and had the fuel pressure tested compared to another 95. Took the plugs out and thye were dry but not white just a little bit of carbon. IDK what else couldbe wrong unless maybe a gasket or bad cat.....
#7
Senior Member
Certified Car Nut
I've had a similar flutter a few times:
1: When something chewed the wiring off an injector
2: For a short time before I replaced the cat
3: When I had the 94 TB w/o the AFC and it was hella lean
1: When something chewed the wiring off an injector
2: For a short time before I replaced the cat
3: When I had the 94 TB w/o the AFC and it was hella lean
#8
Senior Member
Posts like a Corvette
Join Date: Sep 2004
Location: Pittsburgh PA
Posts: 1,539
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by LuxuriesPremier
Does the local advanced have belt dressing? I also changed the oil fule filter oil filter pcv valve 02 sensor plugs wires new air filter. I also checked the compression of all the cylinders and had the fuel pressure tested compared to another 95. Took the plugs out and thye were dry but not white just a little bit of carbon. IDK what else couldbe wrong unless maybe a gasket or bad cat.....
#9
Senior Member
Posts like a Turbo
Thread Starter
Join Date: Jan 2005
Location: Pawtucket, RI
Posts: 333
Likes: 0
Received 0 Likes
on
0 Posts
Belt Dressing
I sprayed a good amount of belt dressing on the belt. Ithelped at first ihadthe boost bypass set to the max and i wasripping tires and what not. then like three hours later took my friends for a drive and it would slip like crazy off the line. I put the boost back to factory no more slipage but not as much power. I was also driving kinda hard and my exhaust got loud all of sudden lol i think i have developed a crack which ihear is quite normal.
Thread
Thread Starter
Forum
Replies
Last Post
billha
1992-1999
18
03-08-2009 05:31 PM