T-stat holes
#1
Senior Member
True Car Nut
Thread Starter
Join Date: Sep 2002
Location: Genoa, Illinois
Posts: 4,013
Likes: 0
Received 0 Likes
on
0 Posts
T-stat holes
KR is bad and I wanna kill it with some COOLNESS. Ok that was lame.
But anyway...how large of holes are recommended to drill into the t-stat and how far out? I think I'll do 2 at the MAX because of how cold it gets here in the winter.
But anyway...how large of holes are recommended to drill into the t-stat and how far out? I think I'll do 2 at the MAX because of how cold it gets here in the winter.
#2
Junior Member
Posts like a Ricer Type-R
1/16" diameter, 2 holes, evenly spaced on the rim from the inside edge to the outside. This should leave the holes unblocked by the rubber seal. Or just install the rubber seal, and go inside of that diameter. Directly across from each other, so the flow isn't pushing up one edge of the stat when it'* closed.
De-burr the holes, top and bottom with a slightly larger drill bit, then rinse it well.
De-burr the holes, top and bottom with a slightly larger drill bit, then rinse it well.
#3
Senior Member
True Car Nut
Join Date: Jun 2003
Location: Purgatory
Posts: 6,313
Likes: 0
Received 0 Likes
on
0 Posts
Re: T-stat holes
Originally Posted by Allmachtige
KR is bad and I wanna kill it with some COOLNESS. Ok that was lame.
But anyway...how large of holes are recommended to drill into the t-stat and how far out? I think I'll do 2 at the MAX because of how cold it gets here in the winter.
But anyway...how large of holes are recommended to drill into the t-stat and how far out? I think I'll do 2 at the MAX because of how cold it gets here in the winter.
Thread
Thread Starter
Forum
Replies
Last Post