CAI heat shield - New design w/picture
#1
Senior Member
Posts like a 4 Banger
Thread Starter
Join Date: Oct 2003
Location: SW Indiana
Posts: 133
Likes: 0
Received 0 Likes
on
0 Posts
CAI heat shield - New design w/picture
Tried something a little different for a heat shield. Used 1/8" plexi and heat molded 2 pieces that fit together around the base of the filter. I will use a black clamp around the circumferance of the shield to hold it in place so it will match the black filter base. Going for the "nearly invisible" look with this one. . The clamp isn't shown in the picture because I didn't happen to have the one I want and suffice it to say the temporary clamp I'm now using wouldn't look to hot in the picture.
Tumbleweed
#4
Senior Member
Certified GM nut
Join Date: Feb 2004
Location: MI
Posts: 2,246
Likes: 0
Received 0 Likes
on
0 Posts
So when is it that you are going to have time to build mine? :P
Hopefully by the end of this week, because there is some ricer that really wants to race next weekend j/k
Hopefully by the end of this week, because there is some ricer that really wants to race next weekend j/k
#6
Senior Member
Posts like a 4 Banger
Thread Starter
Join Date: Oct 2003
Location: SW Indiana
Posts: 133
Likes: 0
Received 0 Likes
on
0 Posts
Logan, Thanks for the reply. I wish I could crank one out for you but man this custom fit stuff takes a lot of time! I probably have about 4 hours in this one and my labor rates are HIGH
#9
Senior Member
Certified Car Nut
Join Date: Aug 2004
Location: My reclining computer chair
Posts: 11,269
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by Logan
Just curious, what size RX-4750 is that? 6inch, 8inch, or 9 inch? (I think those are the three)
Thread
Thread Starter
Forum
Replies
Last Post
GunsOfNavarone
2000-2005
5
05-31-2013 09:46 AM