need some help with code 41 please have tried almost everything i can think of!!
#1
Junior Member
Posts like a V-Tak
Thread Starter
Join Date: Apr 2009
Location: sioux falls sd
Posts: 28
Likes: 0
Received 0 Likes
on
0 Posts
need some help with code 41 please have tried almost everything i can think of!!
so short and sweet i bought my bonnie about 3 months ago (92 bonneville se) for $1000 brand new trans and 160 k on the body. 115 k on the engine (out of a 92 buick regal) car was great for a while then had a prb with code 26 got it to go away then got code 13 replaced the o2 sensor then got code 41 car now had 166 k and still has code 41 and i just had it in the trans shop for a new torque converter and valve body 800$ later and the guy at the shop said the TC and VB were fouled up from the cam sensor being out well i went to the dealer and they tested the cam sensor said it was good, tested the crank sensor said it was good tested the ignition module said it was causing my problems so i replaced that 135$ and still code 41 shook the wires and jimmied them around no luck so i have no idea what it is
it stalls every once in a while when i go to step on the gas
loss of power with ambient temp above 80
19 mpg cty/hw
trans now slips in reverse and has a loss of torque when engine is up to temp
i can hit the gas hard when i first start it in the morn and leave a strip of rubber
if i try that wehn i get done driving it sqeaks a bit and revs out
any help is greatly appreciated =]
it stalls every once in a while when i go to step on the gas
loss of power with ambient temp above 80
19 mpg cty/hw
trans now slips in reverse and has a loss of torque when engine is up to temp
i can hit the gas hard when i first start it in the morn and leave a strip of rubber
if i try that wehn i get done driving it sqeaks a bit and revs out
any help is greatly appreciated =]
#4
Junior Member
Posts like a V-Tak
Thread Starter
Join Date: Apr 2009
Location: sioux falls sd
Posts: 28
Likes: 0
Received 0 Likes
on
0 Posts
no i am actually going to replace them tommorow because i developed a loud tick in the engine at around 1500 rmps and higher but nothing at an idle so im thinkng that it may be because of misfiring... my engine has ran fairly rough for a while but i may also be getting a new bonneville there is a 94 ssei for sale down the rd from me for only 750 bucks so im thinkin that may be plan b if i cant get bonnie fixed lol
#5
Junior Member
Posts like a V-Tak
Thread Starter
Join Date: Apr 2009
Location: sioux falls sd
Posts: 28
Likes: 0
Received 0 Likes
on
0 Posts
now with an interupter magnet wouldn't that be fairly noticible if that was broken or missing when they pulled my crank and cam sensors out?
#6
Senior Member
Posts like a 4 Banger
Join Date: Nov 2006
Location: G-burg,MD
Posts: 121
Likes: 0
Received 0 Likes
on
0 Posts
If you pulled the camshaft sensor and used a mirror to see inside the hole. Then you would have to rotate the crank till you see it or what is left of it.
Code 41: lost cam magnet in 3800
This site is very helpful
Code 41: lost cam magnet in 3800
This site is very helpful
Thread
Thread Starter
Forum
Replies
Last Post
ferullo0
Your Ride: GM Pictures & Videos
14
09-16-2008 12:24 PM