new muffler for SE
06-02-2003, 01:07 AM
#1
Member
Posts like a V-Tak
Thread Starter
Join Date: May 2003
Posts: 34
Likes: 0
Received 0 Likes
on
0 Posts
new muffler for SE
Hi guys, I`m new here so I apologize if I`m posting this in the wrong forum. Got a `94 SE that I want to put a new muffler on with dual tailpipes using the original exhaust pipe. Any suggestions on what muffler, tailpipes, tips would be greatly appreciated. Also, I`m concerned about the exhaust melting the lower bumper as I don`t have the exhaust cutouts in the lower valance like on the SSEIs.
06-02-2003, 01:17 AM
#2
Senior Member
Posts like a Turbo
Join Date: Dec 2002
Location: Upper Left Coast
Posts: 299
Likes: 0
Received 0 Likes
on
0 Posts
I don't know what my muffler guy used to trim my factory cut-outs on the SSE, but it was done nicely so the tips would fit level.
It'* possible to have the guy doing your work cut the valance panel back there to make room for the tips.
I used a MagnaFlow with ANSA dual resonator tips. The tips were a bit too big and he had to customize them a little. One more trip to the exhast shop and I'll be done.
A couple of things need to be 'adjusted'.
If you don't want too much noise or a farty sound with an aftermarket muffler, have a resonator put in.
Good Luck.
Use the Search feature here for some (A LOT) of exhaust or muffler information.
It'* possible to have the guy doing your work cut the valance panel back there to make room for the tips.
I used a MagnaFlow with ANSA dual resonator tips. The tips were a bit too big and he had to customize them a little. One more trip to the exhast shop and I'll be done.
A couple of things need to be 'adjusted'.
If you don't want too much noise or a farty sound with an aftermarket muffler, have a resonator put in.
Good Luck.
Use the Search feature here for some (A LOT) of exhaust or muffler information.
Thread
Thread Starter
Forum
Replies
Last Post