Ebay headers
#1
Senior Member
Posts like a Corvette
Thread Starter
Join Date: Jun 2008
Location: Cleveland, OH
Posts: 1,389
Likes: 0
Received 0 Likes
on
0 Posts
Ebay headers
I'm shopping for headers and I've heard about these "Speed daddy" ones on Ebay
http://cgi.ebay.com/ebaymotors/97-03...Q5fAccessories
How do these compare with TOGs as far as performance, fit, and ease of installation?
Also how much work is it to get them piped into the rest of the exhaust
One last thing, any way the engine will fit back into the car with the headers on, I wanted to swap the heads and throw the headers on with the motor out to make things easy
http://cgi.ebay.com/ebaymotors/97-03...Q5fAccessories
How do these compare with TOGs as far as performance, fit, and ease of installation?
Also how much work is it to get them piped into the rest of the exhaust
One last thing, any way the engine will fit back into the car with the headers on, I wanted to swap the heads and throw the headers on with the motor out to make things easy
#7
Retired Senior Admin
Expert Gearhead
Join Date: May 2006
Location: Sheboygan Wisconsin
Posts: 29,661
Likes: 0
Received 28 Likes
on
24 Posts
The will actually fit in a Bonneville a little better. more room on a H body. However, I'm not sure if the transmission dip still will be a problem. I know when I installed my TOGs I had to switch to a Wbody dip stick. It'* not a big deal, just a little messy.
#9
Senior Member
Posts like a Corvette
Thread Starter
Join Date: Jun 2008
Location: Cleveland, OH
Posts: 1,389
Likes: 0
Received 0 Likes
on
0 Posts
I've done TOGs on a Regal, that was real fun and we bought the bent dipstick ahead to have it
No chance the motor will go in from the top of the front end with the headers bolted up?
No chance the motor will go in from the top of the front end with the headers bolted up?
#10
Retired Senior Admin
Expert Gearhead
Join Date: May 2006
Location: Sheboygan Wisconsin
Posts: 29,661
Likes: 0
Received 28 Likes
on
24 Posts
I don't think it will, but can't say for sure. But if you lay the rear header in place and then lower the engine in, then pull the header in to place, that should work.