SD Headers (Speed Daddy)
#6
DINOSAURUS BOOSTUS
Expert Gearhead
You should be all set. No mount sticking up to mod, no worries of fans, no issues beyond swapping the dipstick tube.
One bit of advice is to take a close look at where they put the O2 bung. I have seen some that hit the body of the W-body cars and would do the same here. However a buddy that bought and installed them last week mentioned the bung was in a different location.
Buy Torca clamps for the front to crossover and crossover to rear, and it would be nice to have a couple underneath as well, but that depends on how you decide to connect.
One bit of advice is to take a close look at where they put the O2 bung. I have seen some that hit the body of the W-body cars and would do the same here. However a buddy that bought and installed them last week mentioned the bung was in a different location.
Buy Torca clamps for the front to crossover and crossover to rear, and it would be nice to have a couple underneath as well, but that depends on how you decide to connect.
Thread
Thread Starter
Forum
Replies
Last Post