P0171
#1
Retired Senior Admin
Expert Gearhead
Thread Starter
Join Date: May 2006
Location: Sheboygan Wisconsin
Posts: 29,661
Likes: 0
Received 28 Likes
on
24 Posts
P0171
P0171
Description
System Too Lean (Bank 1)
The oxygen sensor in bank 1 detected a lean condition (too much oxygen in the exhaust).
Symptoms
You will more than likely not notice any drivability problems, although there may be symptoms such as a lack of power, detonation (spark knock), and/or a hesitation/surge on acceleration.
Causes
A code P0171 may mean that one or more of the following has happened:
Description
System Too Lean (Bank 1)
The oxygen sensor in bank 1 detected a lean condition (too much oxygen in the exhaust).
Symptoms
You will more than likely not notice any drivability problems, although there may be symptoms such as a lack of power, detonation (spark knock), and/or a hesitation/surge on acceleration.
A code P0171 may mean that one or more of the following has happened:
- The MAF (Mass Air Flow) Sensor is dirty or faulty. Note: The use of "oiled" air filters may cause the MAF to become dirty if the filter is over-oiled.
- There could be a vacuum leak downstream of the MAF sensor.
- Low fuel pressure.
- In the vast majority of cases, simply cleaning the MAF sensor does the trick.
- Inspect all vacuum and PCV hoses, replace if necessary, touch fittings, if your finger turns black, replace
- Check for a dirty fuel filter, replace if needed, and proper fuel pressure
- Check for loose sensors, MAF and IAC. The IAC has a O ring that should be checked.
- Check intake manifold, injector "O" rings, EGR adapter,
EGR valve, and EGR feed pipes for vacuum leaks. remove pipe and visually inspect. - Inspect EVAP purge valve for proper function.
- Inspect battery cables for corrosion.
- Inspect engine grounds.
- Check exhaust system for corrosion, loose or missing
hardware. - Test fuel pressure, key on, engine off.
Thread
Thread Starter
Forum
Replies
Last Post