Idle Air control (IAC) valve replacement
Locate your IAC valve, it's on the side of your throttle body. Unplug the valve by lifting the tab, then wiggle and pull the plug, do not pull on the wires.
https://www.gmforum.com/images/statusicon/wol_error.gifThis image has been resized. Click this bar to view the full image. The original image is sized 2048x1536.https://www.gmforum.com/howto/test-pics/PA020015.JPG There are two screws holding the valve in place. One at about 10 O clock. These screws are very snug. https://www.gmforum.com/images/statusicon/wol_error.gifThis image has been resized. Click this bar to view the full image. The original image is sized 2048x1536.https://www.gmforum.com/howto/test-pics/PA020016.JPG And another at about 4 O clock. https://www.gmforum.com/images/statusicon/wol_error.gifThis image has been resized. Click this bar to view the full image. The original image is sized 2048x1536.https://www.gmforum.com/howto/test-pics/PA020017.JPG To remove the valve you will have to twist and pull, it's a tight fit because there is a rubber O ring. https://www.gmforum.com/images/statusicon/wol_error.gifThis image has been resized. Click this bar to view the full image. The original image is sized 2048x1536.https://www.gmforum.com/howto/test-pics/PA020018.JPG Before installing the new valve, lube the rubber O ring with a lite oil, otherwise you risk damaging the O ring. Push in with a slight twist, line up the screw holes and install screws. Plug valve back in. |
All times are GMT -4. The time now is 07:32 PM. |
© 2024 MH Sub I, LLC dba Internet Brands