Changing your spark plugs
Time to change those plugs? No problem. The only tools you will need is a socket wrench, a short extension, a sparkplug socket, a 5/8 or 16mm deep socket will work, and a 13mm socket to remove the cross brace. If you have a air compressor that will be used as well.
You will want your engine to be cool, manifolds get hot and you really don't want to be burning yourself. The first thing you will want to do is remove this cross brace with your 13mm socket. 2 bolts on each side, just lift it off and set it aside. You don't have to remove this, but it will make the job much easier. https://www.gmforum.com/howto/tech-i...4/P3150019.jpg Now, to remove the plugs. Grab and twist the boot, do not just pull it or you could damage the boot and or connector inside. https://www.gmforum.com/howto/tech-i...P9120001-1.jpg Now with your spark plug socket you want to break the plug loose. Give it about a 1/4 to a 1/2 turn. https://www.gmforum.com/howto/tech-i...4/P9120002.jpg Now take your air nozzle and blow any dirt out from around the plug, this way it wont get in to your engine. https://www.gmforum.com/howto/tech-i...P9120003-1.jpg Do one plug at a time so you don't connect the wires to the wrong plug. Before you put your new plugs in, put a small amount of anti seize on the threads. Just near the base of the plug. https://www.gmforum.com/howto/tech-i...4/P3040008.jpg When you take out your old plugs number then and set them aside to inspect them later. https://www.gmforum.com/howto/tech-i...4/P8280001.jpg Using a gapping tool, set your plugs gap. https://www.gmforum.com/howto/tech-i...4/P8280003.jpg When putting new plugs in, DO NOT over tighten them. Hand tight, then a small turn with the wrench. There's a compression seal on the plug. Perhaps a 1/8 of a turn or so. Then connect your wire and move on to the next plug. When all plugs are done, put the cross brace back on and your done. Now go back and inspect your plugs. They should look like this. https://www.gmforum.com/howto/tech-i...4/P8280002.jpg This picture shows a new plug, left, and a worn plug, right https://www.gmforum.com/howto/tech-i...4/P3040006.jpg Here is a link showing different types of problems and what causes them Verrill: Plug Color Chart Notice the sharp edges and light gray color. You don't want to see damage, black, or round edges. If you see anything that simply don't look right, take a picture and post it here. Please note which cylinder it came from, how many miles on the plug, and any other information you think might be useful. There is NOTHING more satisfying then doing your own work. :Thumbs |
All times are GMT -4. The time now is 01:17 AM. |
© 2024 MH Sub I, LLC dba Internet Brands