trans output shaft seal leaking
#1
Member
Posts like a V-Tak
Thread Starter
Join Date: Feb 2007
Posts: 42
Likes: 0
Received 0 Likes
on
0 Posts
trans output shaft seal leaking
I just replace the half shaft on a 2000 montana, sorry for bring this into the bonny forum, but I only get good answers here. The output shaft seal leaks bad after replacing, so I have replaced 2 more seals and it still leaks. I have measure the shaft and they are the same from old one to new one. I have never had any problems like this with replacing half shafts. It really leaks bad in reverse and on a sharp turn. IT is the drivers side. I have had it apart 4 time now... Any help would be grealty appreciated.
Thanks mike
*** This was moved from the Intro to New members to the Lounge ***
Thanks mike
*** This was moved from the Intro to New members to the Lounge ***
#3
Member
Posts like a V-Tak
Join Date: Feb 2009
Location: Green Bay, WI
Posts: 88
Likes: 0
Received 0 Likes
on
0 Posts
carrier bearing would be the other option, but you should be able to feel that while accelerating. do you have the part#'* for the cv & seal you have been putting in there. I can cross reference them at work to be sure your getting the right part where ever your buying them from.
and what is the production date exactly, should be on sticker in door panel
and what is the production date exactly, should be on sticker in door panel
Last edited by jethrow; 04-06-2009 at 06:37 AM.
Thread
Thread Starter
Forum
Replies
Last Post
GunsOfNavarone
General GM Chat
3
11-11-2014 07:41 AM
Brian95Blown
Forced Induction
1
11-10-2004 06:01 PM