1996 gmc yukon flashing p0300
Thread Starter
Junior Member
Joined: Oct 2009
Posts: 1
Likes: 0
1996 gmc yukon flashing p0300
First time GM Forum user.....very frustrated. 1996 GMC Yukon with flashing P0300 random cyl misfire code. Now in driveway up on blocks. Replaced, wires, plugs, rotor, cap, fuel pump, fuel filter, fuel pump relay. No change. Starts easy and runs but missing badly. MLI comes on after 30 seconds and starts flashing. I am debating next replacements. Ignition Coil, Crankshaft Position Sensor, Camshaft Position Sensor, Fuel Regulator, Complete Spider Injection module with new injectors, maybe computer??????? Need an expert opinion on where to go next please. THX
Senior Member
True Car Nut
Joined: Sep 2006
Posts: 4,816
Likes: 245
From: Windsor, Ontario / Detroit, Michigan
Crankshaft position sensor would be a no start, not a misfire.
Fuel pressure regulator can be checked by removing the vacuum hose and smelling for gas. If you smell gas replace it.
Changing the coil is likely the next thing to try.
FWIW, I had a cheap scanner that was giving me a random misfire code. A better scanner showed it was actually one cylinder. How good is your scanner?
Fuel pressure regulator can be checked by removing the vacuum hose and smelling for gas. If you smell gas replace it.
Changing the coil is likely the next thing to try.
FWIW, I had a cheap scanner that was giving me a random misfire code. A better scanner showed it was actually one cylinder. How good is your scanner?
Thread
Thread Starter
Forum
Replies
Last Post
kentiler
GMC/Chevrolet Truck/SUV
14
Dec 9, 2012 07:38 PM