Harmonic Balancer Installer
#1
Member
Posts like a V-Tak
Thread Starter
Join Date: Sep 2010
Posts: 39
Likes: 0
Received 0 Likes
on
0 Posts
Harmonic Balancer Installer
1992 Bonneville SSEi
I'm trying to install my new HB but the center bolt that came with the install kit doesn't fit into the center opening of the HB. I googled like mad and haven't found similar problems, am I doing it wrong? And what do i do with my HB bolt. What happens if I reuse my old one and what do i need to torque it to?
Thanks.
I'm trying to install my new HB but the center bolt that came with the install kit doesn't fit into the center opening of the HB. I googled like mad and haven't found similar problems, am I doing it wrong? And what do i do with my HB bolt. What happens if I reuse my old one and what do i need to torque it to?
Thanks.
#2
Retired
Verify that you ordered the correct HB kit. Do you still have the old bolt to compare it to?
__________________
Retired Administrator
2002 *-10 5.7 V8
2023 Jeep Rubicon Diesel
Retired Administrator
2002 *-10 5.7 V8
2023 Jeep Rubicon Diesel
#5
Retired Senior Admin
Expert Gearhead
Join Date: May 2006
Location: Sheboygan Wisconsin
Posts: 29,661
Likes: 0
Received 28 Likes
on
24 Posts
Oh. I have a write up on removing the HB in tech info. I believe it says what size bolt is needed. It'* not included in the HB puller kit.
Edit: Here it is. https://www.gmforum.com/mechanical-134/harmonic-balancer-replacement-286278/
Edit: Here it is. https://www.gmforum.com/mechanical-134/harmonic-balancer-replacement-286278/
#7
Senior Member
True Car Nut
line up the key and push it on then tighten the bolt just like in dans write up you must use a brand new bolt as stated they are torque to yeild and stretch tighten the bolt and torque to 111 ft lbs the rotate the bolt another 76 degrees this is the stretch just like dan said in his write up then put the splash guard back and the wheel start it up make sure your belt is tracking right and if so away you go