Cold air intake help!!!
02-07-2003, 01:54 PM
#1
Member
Posts like a V-Tak
Thread Starter
Join Date: Jan 2003
Location: Terre Haute In
Posts: 79
Likes: 0
Received 0 Likes
on
0 Posts
Cold air intake help!!!
I ran a cold air intake and set it where the old air box was...
Anyone else done anything else?
Another location?
Suggestions?
Anyone else done anything else?
Another location?
Suggestions?
02-07-2003, 02:09 PM
#2
Junior Member
Posts like a Ricer Type-R
What did you build your box out of? I'm chewing on different types of material myself, but will probably settle on Polycarbonate. Mine will be in the same location, too. Closest you can get to outside air. Other than your CAI, what did you use for an intake?
02-07-2003, 02:48 PM
#3
Member
Posts like a V-Tak
Thread Starter
Join Date: Jan 2003
Location: Terre Haute In
Posts: 79
Likes: 0
Received 0 Likes
on
0 Posts
I bought a cold air intake for a honda civic and ground off the vaccuum hose nub on the pipe and Drilled it out, then jb welded the sensor from the old air box in its place I spent about $50 bucks on it. What a difference it made. I deffinately racommend it. It sucks so much air, it can be heard inside the car!!!
02-07-2003, 03:32 PM
#4
Junior Member
Posts like a Ricer Type-R
Ok, you bought an INTAKE. Not a CAI. A CAI would be the box that shrouds the intake cone filter from the engine bay heat. Quit confusing me! Go up to Techinfo. There'* a section on intake mods.
Thread
Thread Starter
Forum
Replies
Last Post
Snuggles.bf
Performance, Brainstorming & Tuning
6
07-16-2006 03:46 AM
