Anyone know where to get a metal gasket to fit the pacesette
#1
Senior Member
Posts like a Northstar
Thread Starter
Join Date: Jul 2006
Location: Meridian, ID
Posts: 508
Likes: 0
Received 0 Likes
on
0 Posts
Anyone know where to get a metal gasket to fit the pacesette
Anyone know where to get a metal gasket to fit the pacesetter DP between the Y pipe and the DP? Blew out the paper one so I need a fix right away.
#2
Junior Member
Posts like a Ricer Type-R
My suggestion would be to remove it, and measure the ID, OD, and bolt spacing. I seriously doubt it'* anything close to OEM, but we have NFC what to suggest until we know what it is.
#3
Senior Member
True Car Nut
Yes,
You need part number "2001" felpro...this is the 3 hole gasket, its 3" diameter..Napa 7.29 here..
Also its not that it blew out because it was paper, it blew out because from the factory the flanges are not very good on the pace setters. Mine go to a machine shop on monday to mill down the surfaces However I'm going with a metal gasket for piece of mind anyway.
I did the research yesterday and found that one to be a perfect fit.
You need part number "2001" felpro...this is the 3 hole gasket, its 3" diameter..Napa 7.29 here..
Also its not that it blew out because it was paper, it blew out because from the factory the flanges are not very good on the pace setters. Mine go to a machine shop on monday to mill down the surfaces However I'm going with a metal gasket for piece of mind anyway.
I did the research yesterday and found that one to be a perfect fit.
#5
Senior Member
Posts like a Northstar
Thread Starter
Join Date: Jul 2006
Location: Meridian, ID
Posts: 508
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by Hans
Yes,
You need part number "2001" felpro...this is the 3 hole gasket, its 3" diameter..Napa 7.29 here..
Also its not that it blew out because it was paper, it blew out because from the factory the flanges are not very good on the pace setters. Mine go to a machine shop on monday to mill down the surfaces However I'm going with a metal gasket for piece of mind anyway.
I did the research yesterday and found that one to be a perfect fit.
You need part number "2001" felpro...this is the 3 hole gasket, its 3" diameter..Napa 7.29 here..
Also its not that it blew out because it was paper, it blew out because from the factory the flanges are not very good on the pace setters. Mine go to a machine shop on monday to mill down the surfaces However I'm going with a metal gasket for piece of mind anyway.
I did the research yesterday and found that one to be a perfect fit.
Here is the pic for anyone else that needs one in the future:
P.*. Sorry about two posts in a row. Didn't see that before replying.
Thread
Thread Starter
Forum
Replies
Last Post
agrazela
General GM Chat
0
03-03-2008 09:38 PM
phil93bonneville
Buick
6
05-05-2007 11:03 AM