4T65E assembly/rebuild - what is this part?
 

I recently bought a 2003 MOnte Carlo SS. The previous owner cracked the transmission housing when he pulled the engine. He must have forgot a bolt.


I am taking out the guts from that trans and putting it all in a new case. It only has about 30k on a rebuild so there should be a lot of good miles on it yet. I have one small part that I need help with. I am not sure where it goes. Can someone help?


Thanks ahead of time.

That is 4th gear piston accumulator pin that goes in the channel plate

Thanks for your help. I looked a little closer at my diagrams and found it. Your reply allowed me to narrow it down to a specific area. Thanks again!