pulley / belt question
#1
Senior Member
Posts like a Northstar
Thread Starter
Join Date: Jun 2005
Location: Yulee , FL ___ SEBF Survivor
Posts: 700
Likes: 0
Received 0 Likes
on
0 Posts
pulley / belt question
What size pulley should I use to gain horsepower on an L67 with an intake. I also am going to replace the belt, and plugs and idler pulley is necessary. I was thinking about going with a 3.4. With the other mods is that going to cause a lot of KR??
#2
Senior Member
Posts like a Turbo
Join Date: May 2005
Location: Stockton, CA
Posts: 251
Likes: 0
Received 0 Likes
on
0 Posts
First get a scanner to make sure all is and stays well while modding. Then open up the intake and exhaust, 1 step colder plugs, 180 t-stat, no smaller then a 3.4 pulley and see where things are at. PCM would be a good mod as well. And go from there.
Thread
Thread Starter
Forum
Replies
Last Post