Pulley
 

How do you get the pulley off a M62? What tools are needed. Thanks Dennis.

Old junker belt and large channel-locks or vice grips. Hold the pulley still using the belt on the pulley to protect it, and the pliers.

Loosen the nut.

Now use a 3-jaw puller (you may have to remove your coolant reservior depending on the length of the puller) to remove the pulley.

is there 2 nuts holding it on or just the first big nut.

One nut. The left one. :lol:

The other hex you see is in the pulley itself. Ignore it, it's only there to tease you.

DISCLAIMER:
I might be pushing the limits of drunk and fiberglass resin high, but to this date I have not given out bad advice in this condition.

Ok thank you. That helps alot.

If Wren suggests a big hammer...ignore him. ;)

When you pull it off...be wary there is a key underneath that might try to take off. I find a hand under while using the other to remove the pulley that last 1/2 inch works well.