Pulley Measurement?
#1
Member
Posts like a V-Tak
Thread Starter
Join Date: Dec 2006
Location: Mesa, AZ
Posts: 32
Likes: 0
Received 0 Likes
on
0 Posts
Pulley Measurement?
Quick question:
Is a pulley (SC) measured from inside or outside? Meaning, to accurately measure a pulley should I take off the belt and measure where the belt rests or measure to the most outer lip of the pulley (where the belt does not rest).
skelleyaz
Is a pulley (SC) measured from inside or outside? Meaning, to accurately measure a pulley should I take off the belt and measure where the belt rests or measure to the most outer lip of the pulley (where the belt does not rest).
skelleyaz
#8
Junior Member
Posts like a Ricer Type-R
That'* probably WAY too small if you really have a Gen3 M62 on that thing. I'm betting you're getting knock out the ying-yang. Do you have a knock sensor? Any way to scan?
If not, you may be in for some damage soon.
If not, you may be in for some damage soon.
#10
Junior Member
Posts like a Ricer Type-R
That'* a Gen3 alright. I'll tell you I had to do ALOT of work to be able to run a 2.2", much less a 2.0" on mine. And nobody else ever has.
Can I have a closer pic of the pulley?
Can I have a closer pic of the pulley?
Thread
Thread Starter
Forum
Replies
Last Post
OLDsman105
General GM Chat
6
07-08-2005 07:01 PM