SUPERCHARGER REBUILD HELP
#1
Senior Member
Posts like a Supercharger
Thread Starter
Join Date: Aug 2002
Location: Holley, NY
Posts: 190
Likes: 0
Received 0 Likes
on
0 Posts
SUPERCHARGER REBUILD HELP
Can anyone tell me how to seperate the rotors and gears from the intermediate plate on a 95 m62 supercharger?
Salmanman
Salmanman
#2
Junior Member
Posts like a Ricer Type-R
Don't. You'll never get them aligned again.
If you think those bearings and seals are shot, rebuild a used eBay supercharger with good bearings in the intermediate plate.
Or consider a replacement set of rotors pre-mounted from www.canadiansupercharger.com
Needle bearings and nosedrive rebuilding is as far as you should go on your own. Doing what you propose is impossible without a factory alignment jig to pre-set the backlash in the rotors and gears while the gears are pressed back on.
If you think those bearings and seals are shot, rebuild a used eBay supercharger with good bearings in the intermediate plate.
Or consider a replacement set of rotors pre-mounted from www.canadiansupercharger.com
Needle bearings and nosedrive rebuilding is as far as you should go on your own. Doing what you propose is impossible without a factory alignment jig to pre-set the backlash in the rotors and gears while the gears are pressed back on.
Thread
Thread Starter
Forum
Replies
Last Post
baggsend
Forced Induction
5
10-30-2003 02:23 PM