speedometer?
11-15-2006, 12:49 AM
#1
Junior Member
Posts like a Ricer Type-R
Thread Starter
Join Date: Nov 2006
Location: Near St. Louis MO.
Posts: 11
Likes: 0
Received 0 Likes
on
0 Posts
speedometer?
Had a lot of problems with gauges when i got my 94 ssei only one left is the speedometer. any suggestions? could someone post a pic of the speed sensor and its location? HELP!!!!! lol
Thanx
Scott
Thanx
Scott
11-15-2006, 07:09 AM
#2
DINOSAURUS BOOSTUS
Expert Gearhead
The sensor (I think it'* called VSS) is located in the transmission. If I recall correctly it is possible to relplace it without having to pull the transmission.
Someone who had done it should be along shortly. If not..I'll pull out a manual tonight when I get home.
Someone who had done it should be along shortly. If not..I'll pull out a manual tonight when I get home.
11-15-2006, 08:07 AM
#3
Retired
Certified Car Nut
VSS or Vehicle Speed Sensor is located at the end of the passenger side drive shaft output. It is on the differential housing. Best way to get to it would be raise the front of the car off the ground, get underneath and look up. It is located directly behind the engine oil pressure sensor.
Disconnect the wire, remove the one bolt holding the sensor in place, and pull out.
Connect a DVM set to continuity(sp) and pass a piece of metal in front of the sensor. It should beep at you everytime you pass the metal in front of it.
Disconnect the wire, remove the one bolt holding the sensor in place, and pull out.
Connect a DVM set to continuity(sp) and pass a piece of metal in front of the sensor. It should beep at you everytime you pass the metal in front of it.
__________________
Retired Administrator
2002 *-10 5.7 V8
2023 Jeep Rubicon Diesel
Retired Administrator
2002 *-10 5.7 V8
2023 Jeep Rubicon Diesel
11-15-2006, 08:56 AM
#4
Junior Member
Posts like a Ricer Type-R
Thread Starter
Join Date: Nov 2006
Location: Near St. Louis MO.
Posts: 11
Likes: 0
Received 0 Likes
on
0 Posts
ok already replaced that with one i know works. already replaced the gauge cluster and still having the same problem. is there a fuse or relay????? HELP!!!!
11-15-2006, 09:09 AM
#5
Junior Member
Posts like a Ricer Type-R
Unless you had shifting issues also, the VSS couldn't have been the issue. The PCM relies on that input to know when to shift to what gear. 
How about you tell us WHAT your problem with the speedo is, and be as specific as possible.
How about you tell us WHAT your problem with the speedo is, and be as specific as possible.
11-15-2006, 09:27 AM
#6
Junior Member
Posts like a Ricer Type-R
Thread Starter
Join Date: Nov 2006
Location: Near St. Louis MO.
Posts: 11
Likes: 0
Received 0 Likes
on
0 Posts
ok i can do that. When you start the car all the gauges "reset" except the speedo the needle never ever moves at all. no matter what you do. other than that the car shifts and drives normally.
Scott
Scott
11-15-2006, 09:41 AM
#9
Junior Member
Posts like a Ricer Type-R
Thread Starter
Join Date: Nov 2006
Location: Near St. Louis MO.
Posts: 11
Likes: 0
Received 0 Likes
on
0 Posts
no no the gauge never moves EVER no HUD either nothing to tell what speed i'm going. thats the details the gauge never moves for anything under any condition
11-15-2006, 09:45 AM
#10
Junior Member
Posts like a Ricer Type-R
Originally Posted by dragon62243
no no the gauge never moves EVER no HUD either nothing to tell what speed i'm going. thats the details the gauge never moves for anything under any condition
We'll get this narrowed down, then start digging into schematics to further troubleshoot it. We'll get it, it just may take time.