blower motor-manual control
#1
Senior Member
Posts like a 4 Banger
Thread Starter
blower motor-manual control
Wife started car & heard a loud pop & then the fan wouldn't work. I figured it was a fuse but they all checked good. I drove it to work today so mechanic could check codes on my transmission (another problem) & he also checked voltage at the blower motor & it had battery voltage. Figuring it was the blower motor I bought a new one & put it on. Still doesn't work. Connected each motor to battery & they work. I have battery voltage at the connector (purple wire) at all fan settings weather using eng ground or test lead on black wire (other side of connector). I don't understand why I have 11-12v but motor doesn't at least run on high. Also shouldn't the voltage vary with the fan switch setting? What am I missing? I know I might not be looking at this right but it has me stumped.
#2
Retired
Here is the schematic for your application. Same as mine.
__________________
Retired Administrator
2002 *-10 5.7 V8
2023 Jeep Rubicon Diesel
Retired Administrator
2002 *-10 5.7 V8
2023 Jeep Rubicon Diesel
#3
Retired
I just seen your other post. Because I already replied to this one, moving it to Electrical.
__________________
Retired Administrator
2002 *-10 5.7 V8
2023 Jeep Rubicon Diesel
Retired Administrator
2002 *-10 5.7 V8
2023 Jeep Rubicon Diesel
#4
Senior Member
Posts like a 4 Banger
Thread Starter
Thanks for the diagram. I got the blowers to work a little but something must be getting hot & causing voltage drop. Low= volt dropped to 7v, med= 6+v, high = 2.9v. Then it quit working. Thought I blew a fuse but I didn't. After about 15min I had 6-7v at connector. Thinking either resistor assembly or relay. Need help locating the resistor assembly. Need layout of relays in engine fuse block. Don't have diagram on cover. Thanks
#5
Retired
Blower motor resistor is located above and left of the blower motor, underneath the 2 fuse blocks in engine bay. It'* a tight area to get to.
Here are some diagrams...
Here are some diagrams...
__________________
Retired Administrator
2002 *-10 5.7 V8
2023 Jeep Rubicon Diesel
Retired Administrator
2002 *-10 5.7 V8
2023 Jeep Rubicon Diesel
#7
Retired
Your very welcome!
__________________
Retired Administrator
2002 *-10 5.7 V8
2023 Jeep Rubicon Diesel
Retired Administrator
2002 *-10 5.7 V8
2023 Jeep Rubicon Diesel
#8
Senior Member
Posts like a 4 Banger
Thread Starter
OK. The diagram for the resistor block above is not how my 97 looks. It may not matter as the relay is bad. It'* different than the other relays in the fuse block. 5 terminal marked 6158. Is there another one easy to get to on the car? If not I'll get tomorrow after work.
#9
Retired
Might be one in the passenger side fuse/relay center. You have to drop the dash kick panel to get to it.
__________________
Retired Administrator
2002 *-10 5.7 V8
2023 Jeep Rubicon Diesel
Retired Administrator
2002 *-10 5.7 V8
2023 Jeep Rubicon Diesel