Corrosion on switch.
#1
Junior Member
Thread Starter
Join Date: Apr 2006
Location: Purgatory
Posts: 0
Likes: 0
Received 0 Likes
on
0 Posts
Corrosion on switch.
Today I am starting my hardcore deatailing in the bonnie and I popped my switch pod out for the shift/ride/traction. and I decided to take the switch apart. I come to find some corrosion on the terminals and some light corrosion around where the LED'* go into the circuit board. Is this caused from the leaking moonroof? Nothing else in that area is corroded. Here is a blurry arse pic, but will give ya a idea.
#2
DINOSAURUS BOOSTUS
Expert Gearhead
Yikes...
Does the CCR (performance and touring ride) buttons still control the struts or are they disabled already. I'm thinking you would be better off getting another pod.
Does the CCR (performance and touring ride) buttons still control the struts or are they disabled already. I'm thinking you would be better off getting another pod.
#3
Junior Member
Thread Starter
Join Date: Apr 2006
Location: Purgatory
Posts: 0
Likes: 0
Received 0 Likes
on
0 Posts
I'm getting a CCR module and acclerometer from Randy (randman) and Both the lights on the pod were lit up. I was told the back struts were replaced a few years ago, so I guess I'll go searching for a switch pod after I pop in the new CCR.
#4
Senior Member
Certified Car Nut
Join Date: Oct 2003
Posts: 19,756
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by Bonneville94V688
I'm getting a CCR module and acclerometer from Randy (randman) and Both the lights on the pod were lit up. I was told the back struts were replaced a few years ago, so I guess I'll go searching for a switch pod after I pop in the new CCR.
Thread
Thread Starter
Forum
Replies
Last Post
Dutch2005
Everything Electrical & Electronic
30
08-15-2006 12:24 AM