Temp Gauge Issue
#1
Member
Posts like a V-Tak
Thread Starter
Join Date: Feb 2005
Location: Columbus, GA
Posts: 61
Likes: 0
Received 0 Likes
on
0 Posts
Temp Gauge Issue
I just had my upper and lower intake manifolds replaced and i noticed that my temp gauge stays at 100 all day. Could it be the sending unit??
#5
DINOSAURUS BOOSTUS
Expert Gearhead
I'd look in the area where you were working. Knowing that the wiring runs all around the engine bay, you were working on the intake manifold. That'* where I'd zero in. Look at all sensors that you unhooked and rehooked, any obvious things may be the issue.
Temp sensors are usually located by the throttle body end of the motor in 3800'*.
Temp sensors are usually located by the throttle body end of the motor in 3800'*.
Thread
Thread Starter
Forum
Replies
Last Post