Fog light circuit cut out bypass
This write up is how to by pass the fog light shut off when you turn on the high beams. It's not legal to drive with your fogs on with high beams. However I did this because I wanted the circuit to power my intercooler pump. What you do with it is up to you.
Go to the front passenger side, the area under the glove box. https://www.gmforum.com/howto/tech-i...6/P9250001.JPG And remove the 2 bolts, both in front, one on the right side. https://www.gmforum.com/howto/tech-i...6/P9250003.JPG The other on the left side. https://www.gmforum.com/howto/tech-i...6/P9250004.JPG You will also need to remove the thumb screw way in front a bit left of the center of the panel. https://www.gmforum.com/howto/tech-i...6/P9250005.JPG Now drop the panel down to the floor. https://www.gmforum.com/howto/tech-i...6/P9250006.JPG This is the relay panel on the far right side. https://www.gmforum.com/howto/tech-i...6/P9250007.JPG You want the bottom relay. Wiggle it and pull, it will come out. https://www.gmforum.com/howto/tech-i...6/P9250008.JPG Now locate post #1 and wrap a wire around that post. https://www.gmforum.com/howto/tech-i...6/P9250012.JPG Then put the relay back with the other end of the wire sticking out. https://www.gmforum.com/howto/tech-i...6/P9250014.JPG Locate a good ground point. I used the bolt near the center of the passenger area way in front. It's a 10mm bolt. Wrap the wire around and tighten it back up. https://www.gmforum.com/howto/tech-i...6/P9250017.JPG Your now done, put everything back together. Now that relay will not switch over when high beams are turned on. |
All times are GMT -4. The time now is 01:01 PM. |
© 2024 MH Sub I, LLC dba Internet Brands