Clearing the Tails
 

Well first of all, I am going to have to say that I should have looked on here before i did any work to the tails. I am a college student living in an apartment and yes that is where i did all my work. Dremel tool and all. I sort of rushed the process, which i dont recommend. Although they came out alright, I F*** up the trunk piece when i was trying to remove the the orange and red pieces. I forgot to cut out the tabs to make it an easy removal and i wound up stretching the plastic which created an awfull look. So i will do this piece over when i get to the local junk yard. I have some pics to explain though. I will have to say, for me that the hardest part of the whole process was getting the plastic pieces back together. I finally just used a whole lot of silicone to fill in the holes. But untill a week goes by, Im going to be alittle iffy on my glueing process. i did buy some LEDs which i am very impressed with, the cost is about 16.99 a pair. So be ready to spend that if your about to clear your tails. I hope to get everything fixed by next week, so i will post those pics as well.

The LEDs Look real good when your at the certain angle.
https://i82.photobucket.com/albums/j...MG_1137A-1.jpg

You can see the middle piece that i was talking about, looks as though there are air pockets. But this was a foolish mistake on my part and it will be replaced.
https://i82.photobucket.com/albums/j...MG_1135_2A.jpg

Here is a pic of the front cleared.
https://i82.photobucket.com/albums/j.../IMG_1133A.jpg

If i had to do it over again, yeah i would do it. It makes for a great look, it was alittle hassle but when i get that trunk piece done. I will be pleased.

Looks really nice with the front and back both cleared. The back doesn't really look that bad.

if your looking to try again. we have a member that is selling a set
not to far from you.
http://www.bonnevilleclub.com/forum/...ic.php?t=57923