Hey guys I was wondering for clearing your tail lights do you cut right were the plastic starts to bend up were you put ur lights at or on the outter most trim..

( pics show ....RED ARROW means right were it bends....BLUE ARROW means on trim )

PURPLE... well, right in the middle of there... at least I did

so between the blue and red arrow cut it?

yup.. not to deep... watch how far you are cutting from the other side

I'm about 1 cm down and see no orange...I go to the side I cut maybe lil less then 1 cm and I see orange....

Something not right here???

pics would help, i'm not really following you

Ok In the RED circle is were I see Orange reflector

In BLUE circle is were I'm 1 cm down and see nothing

zoom out and take a pic of the whole taillight.. ill draw where to cut..

(tempted to rip off my tailllight to show ya)

Heres several Pics

( I'm half tempted to ask someone on here if I send it to them will they do it with cash! )

you are doing just fine.

once you get those cuts done, that whole piece will be like a flap.. you need to pry the orange piece out of there...