Heater isn't working in 06 impala...??
#1
Member
Posts like a V-Tak
Thread Starter
Heater isn't working in 06 impala...??
Have an 06 Impala 3.9L IP and I can't get the heater to blow hot. I just replaced my AC compressor clutch because my AC wasn't working. Now it seems the heater doesn't want to work. There'* no leaks, radiator fans engage, not low on coolant, thermostat does function, and the waterpump was replaced only a year ago.
When I use to switch from cold to hot or hot to cold, it use to stop what was blowing, and than restart with the cold or hot. Now when I switch from hot to cold or opposite, nothing happens. Is there an actuator that is responsible for switching the temperature controls..??
Help would be appreciated!
When I use to switch from cold to hot or hot to cold, it use to stop what was blowing, and than restart with the cold or hot. Now when I switch from hot to cold or opposite, nothing happens. Is there an actuator that is responsible for switching the temperature controls..??
Help would be appreciated!
#2
Member
Posts like a V-Tak
from 2000 to 2005 GM used the vacuum from the manifold to open and close the blend doors, there was also a small storage tank under the dash near the passenger compartment. In 2006 on they used electronic actuators. I have a 2003 Impala and a 2006 Malibu. I can hear the actuators as the blend doors open and close on the Malibu. Could be the actuators or a fuse.
#3
Member
Posts like a V-Tak
Thread Starter
from 2000 to 2005 GM used the vacuum from the manifold to open and close the blend doors, there was also a small storage tank under the dash near the passenger compartment. In 2006 on they used electronic actuators. I have a 2003 Impala and a 2006 Malibu. I can hear the actuators as the blend doors open and close on the Malibu. Could be the actuators or a fuse.
#5
Member
Posts like a V-Tak
Thread Starter
Thread
Thread Starter
Forum
Replies
Last Post
goldfinger22
2000-2005
10
02-05-2007 05:55 AM