cv shaft chg ? help on a 99 Park AVe
#1
Senior Member
Posts like a Turbo
Thread Starter
cv shaft chg ? help on a 99 Park AVe
to chg the cv shaft do I need to pop out the tie rod or ball joint ?? If so hats a good way to do it w/o damage to the rubber seal ?
#2
Retired Senior Admin
Expert Gearhead
Join Date: May 2006
Location: Sheboygan Wisconsin
Posts: 29,661
Likes: 0
Received 28 Likes
on
24 Posts
You can do it without removing the ball joints. I believe there is enough room to get the axle out with the wheel turned. Or, you can also remove the wheel hub, then the axle will slide right out with ease.
#3
Senior Member
True Car Nut
well first there is this thread with pics that may help
https://www.gmforum.com/mechanical-134/axel-replacement-94-bonneville-se-296711/
and there is also this one..they were both done on bonnevilles but nor much is diffrent
https://www.gmforum.com/showthread.p...el+replacement
https://www.gmforum.com/mechanical-134/axel-replacement-94-bonneville-se-296711/
and there is also this one..they were both done on bonnevilles but nor much is diffrent
https://www.gmforum.com/showthread.p...el+replacement
#6
Senior Member
Posts like a Turbo
Thread Starter
BUT can it be done by removing the wheel bearing and NOT dealing with the tie rod etc ?? Everytime I take a tie rod or ball joint I tear the rubber boot
Thread
Thread Starter
Forum
Replies
Last Post