'98 Buick LeSabre Trans issue; nothing in any gear selection
#41
Senior Member
Posts like a Turbo
#44
Senior Member
Posts like a Turbo
Thread Starter
Front end is badly out of alignment because while it was already apart I replaced lower ball joints, inner and outer tie-rods and struts. However, I did take it for a drive around the block and it did shift. However, PCM needs to relearn the trans. Have to wait a week to get the alignment done so I may try adjusting it some so I can drive it more to see how the shift points will be. I did not install the transgo shift kit because I was running out of money. Since that can be installed without removing the transmission, I decided to drive it a bit and see how it does. If I think it warrants the transgo shift kit, I will install it later when I have money again.
Thread
Thread Starter
Forum
Replies
Last Post