Aurora Hub change....Link
#1
Senior Member
Expert Gearhead
Thread Starter
Aurora Hub change....Link
I wont type this one again..lol
http://aurorah.proboards20.com/index...num=1091471732
Read on if yer interested
http://aurorah.proboards20.com/index...num=1091471732
Read on if yer interested
#2
Senior Member
Posts like a Corvette
Join Date: Jan 2004
Location: Montréal, QC
Posts: 1,374
Likes: 0
Received 0 Likes
on
0 Posts
These 2 items would have helped a lot;
A Slide Hammer Puller will take that hub off easily;
WD40 is next to useless as a penetrating oil;
Looks like you had a good time at least
Cheers,
A Slide Hammer Puller will take that hub off easily;
WD40 is next to useless as a penetrating oil;
Looks like you had a good time at least
Cheers,
#3
Senior Member
Expert Gearhead
Thread Starter
Yeah, liquid wrench came in handy, we used it as well as the WD40...but slide pull hammer eh? Hrm...never thought of that...thanks!
#4
Senior Member
True Car Nut
Did you check the make sure the teeth on the spindle wasn't FAA Zooed up?? lookin @ the back piece.. it seemed you pry where it attatched to the spindle. This may cause issue if it was mangled (teeth warn and bent in spots ) a bit for the next removal.. and or even worse. (teeth worn and bent or rounded )
But glad you did it.. yes yes... now we know why god created swear words..
But glad you did it.. yes yes... now we know why god created swear words..
#5
Senior Member
Expert Gearhead
Thread Starter
We definitely stayed away from the teeth on the driveshaft and the CV boot, for obvious reasons, but the hub when in without an issue (albeit a bit snug).
No problems to report thus far.
No problems to report thus far.
#6
Senior Member
True Car Nut
Thats good to hear..
Jim.. you are earning your nickname this week haven't you.....
You're just lucky I don't have yellow pi$$y supasta powa... or I"d add a line to your sig.. and it would go something like
"JIM "THE TOOLMAN" WALLACE.. hurr hurrr hurrr"
Jim.. you are earning your nickname this week haven't you.....
You're just lucky I don't have yellow pi$$y supasta powa... or I"d add a line to your sig.. and it would go something like
"JIM "THE TOOLMAN" WALLACE.. hurr hurrr hurrr"
Thread
Thread Starter
Forum
Replies
Last Post
valerka
Bonneville GXP/ Northstar Powered Cars
6
08-26-2004 12:08 AM