single power for 2 amps?
#1
Senior Member
Posts like a Camaro
Thread Starter
Join Date: Oct 2003
Location: Hamilton, Ontario
Posts: 1,074
Likes: 0
Received 0 Likes
on
0 Posts
single power for 2 amps?
OK i bought this wiring kit at walmart. it has a 4 ga power lead, then it splits into 2 8 ga powers. I want to run a 500W 4ch amp and a 1000W+ sub amp off of the same power. Would it be ok to use the same power for my ams? or should i run a seperate heavier power direct to the battery? but I dont want to run anymore wires through the car. Would this configuraton be good enough for the power ratings?
#3
Senior Member
Posts like a Corvette
Join Date: Oct 2002
Location: N.W. Indiana
Posts: 1,206
Likes: 0
Received 0 Likes
on
0 Posts
If the power ratings you gave are peak ratings then you should be fine. if it is RMS you would want 4 gauge going into the amps. So you have to get at least a 2 gauge wire or higher. Also if that is RMS rating I would look into getting a new alt. before anything.
#4
Senior Member
Posts like a Camaro
Thread Starter
Join Date: Oct 2003
Location: Hamilton, Ontario
Posts: 1,074
Likes: 0
Received 0 Likes
on
0 Posts
The 4 ch amp is rated at 65 watts rms per channel, so 8 ga should be ok, but the sub amp im looking at is 2000W max, maybe 500 rms. or I might buy a 1000W kenwood. The wiring kit is rated at 1400 watts max.
Thread
Thread Starter
Forum
Replies
Last Post
ibanezcollector
Audio (and aftermarket electronics)
16
12-09-2004 03:20 PM