door panel-- undoing electrical sources
#1
Member
Posts like a V-Tak
Thread Starter
Join Date: Feb 2006
Posts: 67
Likes: 0
Received 0 Likes
on
0 Posts
door panel-- undoing electrical sources
when taking off the door panel to put in my new 4x6'* i try to disconnect the power source from the panel with door locks, window tabs, etc but unless i snip the wires, im not seeing any way to get the whole thing off and out of the way so i can proceed with dismantling the door panel..
#2
Senior Member
True Car Nut
Join Date: Dec 2003
Location: Corn Fields, IN
Posts: 2,767
Likes: 0
Received 0 Likes
on
0 Posts
If I understand what you're saying, there'* a bunch of wires that go into a round plug, and the whole plug should pull away from the switch assembly.
This is a pic of the passenger door, but the driver door should be similar..i've had it apart with no problems.
This is a pic of the passenger door, but the driver door should be similar..i've had it apart with no problems.
#3
Senior Member
Certified Car Nut
Join Date: Oct 2003
Posts: 19,756
Likes: 0
Received 0 Likes
on
0 Posts
actually JDB the Drivers assembly is different that that but it looks the same only much larger......here is what to do
the window switches and the trim have 2 tabs on each side
pull them outwards ( they are soft and will not break)
take the mass of wires and pull sightly to separate them from the window switchs
if the wires dont come off take a flathead screw driver and gently pry the edges up
expect this piece to fit really tight and not want to come off
the window switches and the trim have 2 tabs on each side
pull them outwards ( they are soft and will not break)
take the mass of wires and pull sightly to separate them from the window switchs
if the wires dont come off take a flathead screw driver and gently pry the edges up
expect this piece to fit really tight and not want to come off
Thread
Thread Starter
Forum
Replies
Last Post
708387SW
Classics (Star Chief and 1957 to 1986)
3
04-30-2005 08:01 PM
anthonyv62
Everything Electrical & Electronic
2
01-19-2004 02:27 PM