Angel Eyes fuse/firewall question
#3
Member
Posts like a V-Tak
Thread Starter
Join Date: Oct 2005
Posts: 34
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by corvettecrazy
it depends what kind of bulbs you use.
are you talking about angel eye fog lamps??
are you talking about angel eye fog lamps??
#4
DINOSAURUS BOOSTUS
Expert Gearhead
I think they came with a 15 amp fuse in the supplied wiring harness/relay/fuse holder.
If you hook the driving light part to your stock wiring you will have no issues. Those are already fuxed and relayed.
If you hook the driving light part to your stock wiring you will have no issues. Those are already fuxed and relayed.
#6
DINOSAURUS BOOSTUS
Expert Gearhead
Originally Posted by corvettecrazy
15 amps sounds about right. 10 would likely work.
(55*2watts)/12volts = 9.16667 amps
(55*2watts)/12volts = 9.16667 amps
#7
Member
Posts like a V-Tak
Thread Starter
Join Date: Oct 2005
Posts: 34
Likes: 0
Received 0 Likes
on
0 Posts
Thanks guys. I've got another question. What would have caused the fuse to blow? The car wasn't on, nor were the lights. I was moving the wire to the switch around to try to route it through the firewall, and it blew. Would it have been too close to something else? Would it be bad to put it near an amplifier power cable?
#8
Senior Member
True Car Nut
Join Date: Jun 2004
Location: Rochester, NY (college)
Posts: 6,182
Likes: 0
Received 0 Likes
on
0 Posts
the electricity could have just arced. Possibilities are endless. If it continues to happen I would start to worry. if this is a one time thing, dont worry about it.
#9
Member
Posts like a V-Tak
Thread Starter
Join Date: Oct 2005
Posts: 34
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by corvettecrazy
the electricity could have just arced. Possibilities are endless. If it continues to happen I would start to worry. if this is a one time thing, dont worry about it.
If any of you have installed Angel Eyes, where'd you get them through?
#10
Senior Member
True Car Nut
Join Date: Jun 2004
Location: Rochester, NY (college)
Posts: 6,182
Likes: 0
Received 0 Likes
on
0 Posts
I ran my fog wires down the fender and in through the door accordian
Definely not the best place to do it but I was running out of summer to enjoy all my mods. Where you amp cable is should be fine as long as they are not rubbing on the firewall and therefore rubbing through to expose open wire.
Definely not the best place to do it but I was running out of summer to enjoy all my mods. Where you amp cable is should be fine as long as they are not rubbing on the firewall and therefore rubbing through to expose open wire.